ISC and EA Elektro-Automatik welcome you to this webinar on EA
Elektro-Automatik's cutting-edge DC Bidirectional programmable power
supplies and regenerative electronic loads that have been serving automotive
applications worldwide with testing solutions for
- Energy Storage (Batteries, Fuel Cells)
- Vehicles (PHEV, BEV, FCEV) for ground, sea and
air
- Power Conversion (DC/DC, DC/AC, AC/DC)
This webinar will also shed more light on the exciting new launch of EA
Elektro-Automatik EA-BT 20000 range of triple-output battery testers! The
EA-BT 20000 battery testers can simultaneously test three batteries, thus
accelerating test rates compared to instruments with a single output.
Furthermore, the webinar will discuss how the EA-PSB 10000 programmable
power supply improves testing as per the German LV123 Automotive Standard.
| Date |
7th Sept 2023, Thursday |
| Time |
3.30 PM - 4.30 PM IST |
| Planned Duration |
45 minutes, followed by Q&A |
| Hosts |
Experts from EA Elektro-Automatik, Germany |
EA-PSB 10000, EA-PSI 10000, EA-ELR 10000: Highest Power Density in the
smallest footprint
Conventional or Bidirectional Power Supplies and Electronic Loads with
Energy Recovery
- Bidirectional power,
autoranging
- Up to 1.92MW in a rack system
- Battery, Fuel Cell, Photovoltaic
Simulations
- Air- and water-cooled variants
- 30kW power in 4U, 19", 2000V
- 60kW power in 6U, 19", 2000V
|
Upto 1.92MW in a rack system
|
EA-BT 20000
Battery Tester with Triple Output
Integrated solution 2-quadrant devices for charging and discharging of
battery cells, modules or packs
- Energy recovery with an efficiency of up to
over than 96 %.
- Significant savings of kilowatt hours
- No conversion of energy into heat / No
cost-intensive air conditioning
- Fast amortization of the EA-BT 20000
units
- Software EA-Power Control and EA-Battery
Simulator
- For configuration and test procedure without
programming language
- Via connection with PC or programmable logic
controller (PLC)
- Two operating modes: SCPI commands for
program control from a PC/ModBus commands for program
control from a PLC
- Flexible communication interfaces: Gbit
Ethernet, ProfiNet, CAN-FD, or
EtherCAT™
- 2nd sense input for
- detection of wrong battery
polarity
- or detection of accidently
swapped cell fixtures
- Galvanically isolated share bus for parallel
operation
- Master-slave bus for parallel
operation
- Wide voltage, current and power range
- For a wider field of operation than
conventional battery testers
Battery Packs
Battery Cells
Fuel Cells
EV Charging Systems
HV-Inverter
EV/PHEV
On-Board Chargers
HV Fuses
For testing & simulating:
- Battery systems for electromobility
and renewable energy sources
- Fuel cells for mobile, portable and
stationary applications
- Photovoltaics for solar energy
